Wall Panelling Installation · Service

Wall Panelling Installation

Bespoke wall panelling — designed against your wall, built and fitted by our joiners, then sprayed in-house to a furniture-grade finish.

  • Fully insured · £5m public liability cover
  • Dustless sanding where relevant
  • Premium paint systems · clean protected work
  • Residential and commercial
Short answer

Do Four Oaks Painting & Decorating fit and decorate wall panelling?

Yes. We measure, fit, fill, caulk, prime and decorate bespoke wall panelling in hallways, staircases, bedrooms, dining and living rooms across Sutton Coldfield, Four Oaks, Birmingham and the West Midlands.

About this service

What's involved.

Most wall panelling failures come from layouts forced onto walls they don't fit. We measure the wall, work out the panel proportions that look correct, and only then start cutting.

Our joiners handle the build and fit; the same team sprays the finished wall in our HVLP setup so there's no brush-and-roller texture across panels that are supposed to be flat and even.

We work across Sutton Coldfield, Four Oaks, Mere Green, Little Aston, Lichfield, Tamworth, Birmingham, Solihull and surrounding areas.

  • Pre-primed MDF panelling
  • Square, shaker, Georgian and bespoke layouts
  • Set out to wall length, not catalogue
  • Fitted, filled and caulked properly
  • Sprayed to furniture-grade finish
  • One team, no trade hand-offs

Quote for wall panelling installation

Tell us about your project and upload a few photos for a faster estimate. We typically respond within one working day.

Upload clear photos of the rooms, exterior, stairwell, woodwork or surfaces you'd like decorating. Up to 6 images.

  • 15+ years' experience
  • £5m public liability
  • 9.97/10 on Checkatrade
  • Details used only to reply

We'll only use your details to respond to your enquiry. We do not sell your data.

Our process

How the work runs.

01

Design & layout

Pencil mock-up on the wall so you see exactly where each rail and stile lands before we cut anything.

02

Build

Cut and fixed with adhesive and pins, plumbed and levelled to the wall.

03

Make good

Joints filled, edges caulked, pin holes flushed, full sand back.

04

Prime & spray

Adhesion primer, then two to three sprayed topcoats in your colour.

05

Reinstall

Skirting, sockets and switches set back proud where required.

Ideal for

Who this works for.

  • Hallways, staircases and landings
  • Bedrooms — headboard and full walls
  • Lounges and dining rooms
  • Boot rooms and snug spaces
  • New-build feature walls
Where we work

Sutton Coldfield, Four Oaks and the wider West Midlands.

We work across Sutton Coldfield, Four Oaks, Mere Green, Little Aston, Lichfield, Tamworth, Birmingham, Solihull and surrounding areas.

FAQs

Common questions.

How is sprayed panelling better than rolled?+

Spraying gives an even, brush-free, roller-stipple-free finish across the whole wall. Rolled panelling shows texture differences between panels and frames in raking light.

Do I need to remove sockets?+

We isolate sockets and switches and refit them proud of the new face — handled with an electrician where rewiring is required, otherwise included.

Will it crack if the house moves?+

We fit with adhesive and pins, then caulk and prime; the caulk handles seasonal movement. Hairline cracking is rare and easily touched in.

Can you panel onto plasterboard / dot-and-dab walls?+

Yes. Adhesive and pins find the board fine; we add extra fixings where there's structural framing behind.

Get in touch

Planning a project? Send us a few photos and we'll let you know the best way forward.

Upload photos for a fast estimate.

Send up to 6 photos of the areas you'd like decorated and we'll come back to you with clear next steps.